Hi @mila_diaz ,
Once a device is disenrolled or removed from the Hexnode UEM portal, Hexnode UEM can no longer send new remote commands to it. Remote actions such as Wipe require an active MDM communication channel between the device and the portal. If that management link has already been broken, the wipe command will not reach the device.
In this case, the remaining MDM configuration must be cleared directly on the device by performing a local factory reset.
Use the reset option for the device platform:
- Android: Settings > System > Reset options > Erase all data (factory reset)
- iOS/iPadOS: Settings > General > Transfer or Reset [Device] > Erase All Content and Settings
- Windows: Settings > System > Recovery > Reset this PC
- macOS: Use System Settings > General > Transfer or Reset, or boot into Recovery Mode and erase/reinstall as needed
After the local reset, the device-side enrollment configuration will be removed. If the device needs to be managed again, it must be re-enrolled in Hexnode UEM.
Regards,
Isabel Lora
Hexnode UEM