Windows policy removal stuck pending with Hexnode app sync failedSolved

Participant
Discussion
4 weeks ago Oct 20, 2026

A Windows laptop still shows a policy removal as pending even though the policy was dissociated quite a while ago. The device appears active in the portal and the laptop was restarted once, but the status did not change. A Scan Device action has also been in progress for a few hours. When trying to sync from the Hexnode app on the device, it only shows “Sync failed” in red with no other error message. The device has CrowdStrike EDR installed. What should I check next?

Replies (1)

Marked SolutionPending Review
Hexnode Expert
4 weeks ago Oct 20, 2026
Marked SolutionPending Review

Hello @maatthew ,

If the device is active in the Hexnode UEM portal but policy removal remains pending and a device scan is stuck in progress, the issue is likely with the device-side check-in or network connectivity used by the Hexnode UEM app.

Try the following steps on the Windows device:

  1. Connect the device to a different network, preferably one without restrictive firewall, proxy, or security filtering rules.
  2. Restart the laptop completely.
  3. After the restart, open the Hexnode UEM app on the device.
  4. Trigger a manual sync from the Hexnode UEM app.
  5. Wait for the device to check in and then verify whether the pending policy status clears in the portal.

Since CrowdStrike EDR or similar endpoint protection tools are installed, also ensure they are not blocking the Hexnode UEM app or its network communication. If the Hexnode UEM app cannot reach the required Hexnode services, sync may fail even though the device still appears active in the portal.

Avoid repeatedly forcing Scan Device or other continuous actions while previous actions are still in progress, as this can interfere with pending device actions or cause actions to remain queued longer.

Regards
Simon Scott
Hexnode UEM

Save